China 125 Amp MCBs Manufacturer, Supplier, Factory

High quality customized products Drop type fuse cutouts are outdoor high voltage protection facilities. The fuse is installed at high voltage side of transformeror branch line of distribution line to protect transformer or transmission line from short circuit and overload,to break and connect load current.

◆ Use Conditions of ZW32-40.5 Outdoor HV Vacuum Circuit Breaker
1.Ambient temperature: -30℃~+60℃;
2.Altitude: ≤3000m;
3.Wind speed: ≤34m/s;
4.Pollution grade: ≤IV.
5.Storage temperature: -40℃~+85℃.

China XUCKY Electric customized LXK Current Transformer at 35kV and below. AC 50Hz line for the power system as well as the high voltage three-phase alternator, the motor's zero sequence over-current protection,and applies only to indoor. The outer diameter of the output cable is not greater than 120mm.
●This type of transformer is divided into two halves.Into a half circle type cast resin,and then clamping hoop connection.
●Installation can be mounted transformer is divided into two halves.Then merged into one,very easy to install.

XUCKY Electric is a large-scale CJX2 Contactor manufacturer and supplier in China. CJX2 Contactor (LC1) (AC/DC contactor, hereinafter referred to as contactor), mainly used for the circuit of AC 50Hz (or 60Hz), the voltage to 660V, the rated operating current to 95A in the utilization category of AC-3, 400V (380V), for the remote on and off circuit, frequent start and control AC motor, and combine with the appropriate thermal relay to form electromagnetic starter to protect the circuit may occur overload operation.

ZW20-12 Series Outdoor High Voltage Vacuum Circuit Breaker is a 3-phase AC 50Hz 12kV outdoor switch equipment.
♦ Installation way: pole mounted;
♦ Pole type: integrated pole;
♦ Application: outdoor 12kV substation, power plant.
♦ Operation type: manual, electric, remote control.

The ID RCCB (Residual Current Circuit Breaker) and the F360 RCCB are two different models of L3-63 residual current circuit breakers, which are essential components in electrical systems designed to ensure safety by interrupting the circuit when an imbalance in current is detected, typically due to a ground fault or leakage current.