Q3 Automatic Transfer Switch

Scope of Application

Q3 Automatic Transfer Switch (hereinafter referred to as ATS), it is suitable for the power supply system of AC 50Hz, rated voltag f 400V, rated current of 63A and below. Choice and conversion between two power supply according to the needs. ATS have protection functions of overload, short circuit, under-voltage, but also have functions of fire, double breaking and output closing signal. Particularly applicable to the lighting lines in office buildings, shopping malls, banks, high-rise buildings and other places with needs of the fire.

Q3 Automatic Transfer Switch complies with GB / T14048.11 standard.

Models and Specifications

Normal operating conditions and installation conditions

● The altitude of the installation site should not exceed 2000m.

● Ambient air temperature

Ambient air temperature does not exceed the upper limit is +40℃; the average ambient air temperature in 24h does not exceed +35℃. The ambient air temperature lower limit is not less than -5 ℃.

● Atmospheric conditions

○ Humidity

At the maximum temperature of +40℃, the air relative humidity is less than 50%, there is a higher relative humidity allowed at lower temperatures, for example, up to 90% at 20℃. Special measures should be taken for gel that is occasionally generated due to changes of humidity.

○ Pollution degree: 3

● Installation conditions

Installed in the place without shock and invasion of rain and snow ; the upper terminal connect to the power side, the lowr terminal connect to the load side; the inclination between products and vertical plane is not more than 5°.

● Installation category: Ⅲ

● The external magnetic field near the installation site does not exceed 5 times the geomagnetic field in any direction.

Technical parameter

Basic parameters of Q3 Automatic Transfer Switch see Table 1

Basic parameters of terminal type and intelligent type of Q3 Automatic Transfer Switch in Table 2

Outline and mounting dimensions

Installation

Connection wire (cable) for ATS uses single core polyvinyl chloride (PVC) insulated copper wire or equivalent copper bar, the sectional area is selected according to the table 4.

Wiring diagram of ATS

Wiring diagram of four-pole switch

Wiring diagram of three-pole switch

Wiring diagram of ATS output terminals

Wiring diagram of commom type output terminals

Wiring diagram of intelligent type output terminals

Ordering Information

Users must specify when ordering:

7.1 Name and type of Q3 Automatic Transfer Switch;

7.2 The rated current (A) of Q3 Automatic Transfer Switch;

7.3 Poles (four-pole, the ATS is three-phase four-wire system when the customer does not indicate);

7.4 Controller type of Q3 Automatic Transfer Switch;

7.5 Quantity.

7.6 Customer requirements for Miniature Circuit Breakers DZ47 or C65

For example: ordering Q3 Automatic Transfer Switch, three-pole, rated current of 6A, common type, the number of 100 units. Can be written as: Q3-63 / 3P 6A 50 units.

Order Q3 Automatic Transfer Switch, four-pole, rated current of 63A, intelligent type, miniature circuit breakers require 50 DZ47D type. Can be written as: Q3-63 / 4P 63A DZ47D 100 units.